The design and manufacture of a suite of tools for aircraft wing manufacture

Concepts

• bristol
• miscellaneous machinery
• national composites centre
• manufacture of a suite of tools
• suite of tools
• aircraft wing manufacture
• mould tools
• wing covers
• manufacture of all constituent parts
• tools

Location

United Kingdom:

Description

There will be a requirement for a suite of tools to enable the manufacture of a complete set of wing covers Port, Starboard, Upper & Lower. The wing covers will be manufactured from Aerospace pre-preg composite materials which will be cured in the National Composites Centre large Autoclave. Each of the Cover assemblies will consist of a Cover Panel as well as integral stringers. The tools in scope for this project will include all mould tools as well as all lifting and handling provision to enable the manufacture of all constituent parts and the integration of these parts into their respective assemblies. The rough sizing for each of the individual wing covers will be approximately 6m span, 1.4m chord with a typical aero surface. The program for works is estimated to be in the order of 7 months, with initial geometry data drop in November 2021 and final geometry January 2022 with tools required on dock at the NCC at the end of May 2022.

Total Quantity or Scope

Suppliers can express their interest in this opportunity by sending an email to Catherine Summers catherine.summers@nccuk.com. Release of further information will depend on acceptance and signature of the NCC Non-Disclosure Agreement, which will be emailed to you in response to your expression of interest.

CPV Codes

• 42900000 - Miscellaneous general and special-purpose machinery

Indicators

• This is a one-off contract (no recurrence)
• Renewals are not available.

Other Information

** PREVIEW NOTICE, please check Find a Tender for full details. **